Brother HL-1870n Network User's Manual page 81

The following steps apply to configuring a remote printer on NetWare 3.xx
systems:
6.
a. Select print server Information from the PCONSOLE main menu
and choose the name of the PSERVER NLM.
b. Select print server configuration and then printer configuration.
Select any "Not Installed" printer and press Enter. Remember the
number of this printer, since it will be used later in the configuration
process.
c. If desired, type in a new name for the printer.
d. Go to Type, press ENTER, highlight Remote Other/Unknown and
press ENTER again. The other settings in this menu are not required.
e. Push ESCAPE and save the changes.
f. Push ESCAPE and select Queues Serviced by Printer.
g. Highlight the printer name that you just configured and press
ENTER.
h. Press INSERT, choose the desired print queue, and press ENTER
(you can accept the default priority).
i. Press ESCAPE several times to exit PCONSOLE.
Assigning the Remote printer name and number using BRCONFIG
7.
a. Execute the BRCONFIG from the Windows menu.
b. Select the Brother print server from the list of print servers. When
you get the message that the print server is connected, press the
ENTER key and type Where the default password "access" in
response to the "#" prompt (the password will not echo) and then
press the ENTER key again in response to the Enter Username>
prompt. When you get the Local> prompt, type:
SET NETWARE NPRINTER nlm number ON service
SET NETWARE RESCAN
EXIT
•
Where nlm is the name of the PSERVER NLM on your file
server
•
Number is the printer number (must match the printer number
you selected during the PCONSOLE configuration in the
previous steps)
•
Service is the name of the service assigned by NetWare print
server name(where the default services are BRN_xxxxxx_P1
for the Brother printer, where "xxxxxx is the last six digits of
the Ethernet address (MAC address)).
CHAPTER 6 NOVELL NETWARE PRINTING
6-17