Table of Contents
Advertisement
Available languages
Available languages
Installation
Unpacking
1.
Remove all packaging material, including the foam base and all adhesive tape holding the
cabinet accessories inside and outside. Slide out and remove plastic or foam guard used to
secure the compressor from shipping damage due to vibration and shock.
2.
Inspect and remove any remains of packing, tape or printed materials before powering on the
cabinet.
Leveling
Your cabinet has 4 leveling bolts located in the front and rear corners of your cabinet. After
properly placing your cabinet in its final position, you can level your cabinet.
Leveling bolts can be adjusted by turning clockwise to raise or counterclockwise to lower
your cabinet. The cabinet door will close more easily when the leveling bolts are extended.
Proper air circulation
To assure your cabinet works at the maximum efficiency it was designed for, you should
install it in a location where there is proper air circulation, plumbing and electrical
connections.
The following are recommended clearances around the cabinet:
Sides: 2" (50mm)
Top: 2" (50mm)
Back: 2" (50mm)
Do not over fill your cabinet for proper internal air circulation.
Electrical requirements
Make sure there is a suitable power outlet (250 volts 16 amps) with proper grounding to
power the cabinet.
Avoid using 3 plug adapters or cutting off the third grounding in order to accommodate a 2
plug outlet. This is a dangerous practice since it provides no effective grounding for the
cabinet and may result in shock hazard.
Install limitations
Do not install your cabinet in any location not properly insulated or heated. Your cabinet is
not designed to operate in temperature settings below 12°C.
Locate the cabinet on a hard and flat surface away from direct sunlight or heat source, e.g.
radiators, baseboard heaters, cooking appliances etc. Any floor unevenness should be
corrected by leveling legs located on the front and rear bottom corners of the cabinet.
Your cabinet is designed for free-standing installation only, not for built-in application.
Advertisement
Table of Contents
