Lan Setup - D-Link AMPLIFI DAP-1525 User Manual

Section 3 - Configuration
This section will allow you to change the local network settings of the bridge and to configure the Static settings.
Enter the Device Name of the AP and click Next to
Device Name:
continue. It is recommended to change the Device
Name if there is more than one D-Link device within
the subnet.
LAN Use the drop-down menu to select Static IP if your ISP
Connection assigned you the IP address, subnet mask, gateway,
Type: and DNS server addresses. Select Dynamic IP (DHCP)
to automatically assign an IP address to the computers
on the LAN/private network.
IPv4 Address: Enter the IP address assigned by your ISP.
Subnet Mask: Enter the Subnet Mask assigned by your ISP.
Default Enter the Gateway assigned by your ISP.
Gateway:
Primary DNS Enter the primary DNS server IP address.
Server:
Secondary DNS Enter the secondary DNS server IP address.
Server:
My IPv6 Select the mode you would like the router to use to
Connection: connect to the IPv6 Internet from the drop-down
menu.
D-Link DAP-1525 User Manual

Lan Setup

50