Removing The Hp Usb+Power Card - HP Point of Sale rp5000 Hardware Reference Manual

Hardware Upgrades

Removing the HP USB+Power Card

Ä
✎
2-12
CAUTION: For the computer to operate properly, an HP USB+Power
card must be installed in the Acclerated Graphics Port (AGP) slot.
An AGP card will not work in the AGP slot.
To remove the card from the AGP slot:
1. Turn off the computer properly through the operating system,
then turn off any external devices.
2. Disconnect the power cord from the power outlet and disconnect
any external devices.
3. Remove the computer access panel (see
Computer Access Panel and Front Bezel"
4. Locate the USB+Power card on the system board.
5. Lift up the slot cover retention latch that secures the card.
Releasing the Slot Cover Retention Latch
www.hp.com
"Removing the
in this chapter).
Hardware Reference Guide