Manually Resetting the Controller to Factory Defaults
Manually Resetting the Controller to Factory Defaults
To reset the controller to factory defaults using the Reset button, follow these instructions:
Step 1
Place a straightened paper clip into the Reset button hole (see
Step 2
While observing the controller LEDs, gently push and hold the Reset button with the paper clip.
Step 3
When the Alarm LED turns green, release the Reset button by removing the paper clip.
The controller power cycles and reboots. The controller configuration settings are reset to factory
Step 4
defaults and the startup wizard GUI appears.
Cisco 500 Series Wireless Express Mobility Controller Configuration Guide
6-12
Chapter 6
Restarting, Resetting, Backing Up, and Restoring the Controller
Figure
6-14).
OL-15283-01