Midi Receive Settings - Yamaha Tyros2 Owner's Manual

Reference
MIDI
I MIDI messages which can be transmitted or received (recognized)
The following MIDI messages can be set on the TRANSMIT/RECEIVE display.
G NOTE..................................................................................................page 132
G CC (Control Change)........................................................................page 132
G PC (Program Change) ......................................................................page 132
G PB (Pitch Bend) ................................................................................page 132
G AT (Aftertouch) .................................................................................page 132

MIDI Receive Settings

The explanations here apply when you call up the RECEIVE page in step #5 of the Basic Procedure on page 214. This determines
which parts will receive MIDI data and over which MIDI channels the data will be received.
Select a channel. The Tyros2 can
receive MIDI messages over 32 chan-
nels (16 channels x 2 ports).
Determines the part to which the received MIDI messages of
the selected channel are assigned. With the exception of the
two parts below, see page 179 for details about the parts.
• KEYBOARD
The received note messages control the Tyros2's key-
board performance.
• EXTRA PART1–4
There are four parts specially reserved for receiving and
playing MIDI data. Normally, these parts are not used by
the instrument itself. The Tyros2 can be used as a 32-
channel multi-timbral tone generator by using these four
parts in addition to the parts (except for the microphone
sound) described on page 179.
I MIDI transmission/reception via the USB terminal and MIDI terminals
The relationship between the MIDI terminals and the USB terminal which can be used for transmitting/
receiving 32 channels (16 channels x 2 ports) of the MIDI messages is as follows:
G MIDI reception
MIDI A IN
terminal
Merge
MIDI A01–16
216
Tyros2 Owner's Manual
USB MIDI B IN
connector terminal
Port handling
USB1 USB2
Merge
MIDI B01–16
The dots corresponding to each
channel (1–16) flash briefly whenever
any data is received on the chan-
nel(s).
Turns reception of the specified data type of the
selected channel on or off.
NOTE
To switch the desired Registration Memory via MIDI
(1) Set "PART" to "KEYBOARD."
(2) Send the following MIDI messages from an external
device in the following sequence.
BANK MSB/LSB: Target Registration Memory Bank File
number(*)
* File Number corresponds to the sorted order of the
current drive. The value of the first file is 00H.
Program number (PC): Target [REGISTRATION MEM-
ORY] button number (0–7)
Example: When selecting [REGISTRATION MEMORY]
button number 4 of the 3rd Registration Memory Bank
File, the values are: MSB/LSB/PC = 00H: 02H: 03H
G MIDI transmission
MIDI A OUT
terminal connector
MIDI A01–16
.................
............
USB MIDI B OUT
terminal
MIDI B01–16