Table of Contents
Advertisement
• Do not remove both of the AC adapter and the battery pack from the
MP series when turning it off. Otherwise, you cannot use the
DirectHD function. If you remove them, start Windows of the MP
series, finish it and then, connect to the host computer.
2.
Connect the AC adapter to the MP series.
3.
Connect your MP series and your host computer with the provided DirectHD
cable. (Refer to the Connecting MP Series to Host Computer section on the next
page.)
4.
On the screen of your host computer, click start – Run....
5.
Click Browse... button.
6.
Open My Computer – SHP_V2600U(E:) – DIRECTHD.
The drive name (E:) differs depending on the environment of your host
computer.
7.
Select setup and click Open.
8.
Confirm the file name to be run is correct and then, click OK.
9.
Follow the on-screen instructions.
10. Click Yes to restart the host computer.
Status Indicator for DirectHD
The following indicators show the status when the DirectHD function is used.
Battery Indicator
Red (blinking): Remained low
DirectHD READY Lamp
Green: Connected
Off : Not connected
Hard Disk Indicator
Green: Accessed by your host computer
6
6-3
Advertisement
Table of Contents
