Power Control; Energy Save; No Signal Off (Av Source Only) - Pioneer PDP-5010FD Operating Instructions Manual

Adjustments and Settings
11
Sound Effect
You can select from SRS FOCUS, SRS or SRS TruBass.
1
Press HOME MENU.
2
Select "Sound" ( /
3
Select "Sound Effect" ( /
4
Select "SRS FOCUS", "SRS" or "SRS TruBass" ( / ).
5
Select the desired parameter ( / ).
SRS FOCUS
Selections Off
On
SRS
Selections Off
On
SRS TruBass
Selections Off
On
6
Press HOME MENU to exit the menu.
Note
• (WOW) denotes a status where SRS FOCUS
®
SRS and SRS TruBass
• You cannot adjust the sound effect for listening with
headphones.
• If you change the sound effect with headphones connected,
the new setting will become effective as soon as you
disconnect the headphones.
• The effect of this function differs depending on signals.
64
En
then ENTER).
then ENTER).
®
Deactivates SRS FOCUS
®
Activates SRS FOCUS
Shifts the apparent direction of the sound
upward for more clearly defined sound
®
Deactivates SRS
®
Activates SRS
Reproduces highly effective three-
dimensional sound
®
Deactivates SRS TruBass
®
Activates SRS TruBass
Provides deep, rich bass using a new
technology
®
are on.

Power Control

Power Control provides convenient functions for saving power.

Energy Save

You may use one of the three Energy Save modes to save power
consumption.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "Energy Save" ( /
4
Select "Mode 1", "Mode 2", or "Picture Off" ( /
ENTER).
Item Description
Off Does not decrease picture brightness
Mode 1 Slightly lowers power consumption while slightly
suppressing the brightness drop level
Mode 2
Decreases the picture brightness and lowers power
consumption
Picture Off
Deactivates the screen to save power. To restore the
screen display, press any button other than VOL +/–
and MUTING.
This setting is not memorized by the system.
5
Press HOME MENU to exit the menu.
Note
• When you change the Energy Save mode, you may notice a
change in the panel sound. This is normal.
• Energy Save maintains efficiency of the screen for a long
period of time by decreasing picture brightness and lowering
®
,
power consumption. Setting Energy Save to "Mode 1" is
recommended for increased efficiency.

No Signal off (AV source only)

The system will be automatically placed into the standby mode if
no signal is received for 15 minutes.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "No Signal off" ( /
4
Select "Enable" ( /
Item Description
Disable Does not place the system into the standby mode
(default)
Enable Places the system into the standby mode if no signal
is received for 15 minutes
5
Press HOME MENU to exit the menu.
Note
• Five minutes before the system is placed into the standby
mode, a message appears every minute.
• The system may not be placed into the standby mode when
noise signals are present at the plasma display after a TV
program finishes.
then ENTER).
then ENTER).
then ENTER).
then ENTER).
then ENTER).
then