Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 53

Chapter 2 Installing Cisco Network Modules in Cisco Access Routers
Installing Cisco Network Modules in Cisco Access Routers
This section describes installation tasks for Cisco network modules used on Cisco access routers, and
contains the following subsections:
•
•
•
•
•
The following routers do not support online insertion and removal (OIR) of network modules:
Note
•
•
•
•
•
•
•
To avoid damaging the router, turn off electrical power and disconnect network cables before inserting
or removing a network module into these routers.
Tools and Equipment Required During Cisco Network Module Installation
You will need the following tools and equipment while working with Cisco network modules:
•
•
•
OL-2485-20
Tools and Equipment Required During Cisco Network Module Installation
Installing and Removing Blank Faceplates
Installing Blank Faceplates on Cisco Access Routers
–
Removing Blank Faceplates from Cisco Access Routers
–
Preparing Cisco Router Slots for Network Module Installation
Installing Slot Dividers
–
Removing Slot Dividers
–
Installing Slot Adapters
–
– Removing Slot Adapters
Installing Single-Wide, Extended Single-Wide, and Extension Voice Network Modules in Cisco
Access Routers
Installing Double-Wide and Extended Double-Wide Network Modules in Cisco Access Routers
Cisco 2600 series
Cisco 2811
Cisco 2821
Cisco 2851
Cisco 3620
Cisco 3640
Cisco MWR 1941-DC
Number 1 Phillips screwdriver or a small flat-blade screwdriver
ESD-preventive wrist strap
(For routers using DC power) Tape to secure DC circuit breaker handle
Installing Cisco Network Modules in Cisco Access Routers
Cisco Network Modules Hardware Installation Guide
2-5