Canon VB-C500D Operation Manual page 23

Note
For [IP Address], [Subnet Mask] and [Default Gateway Address], contact your network
administrator.
If any of the [IP Address], [Subnet Mask] and [Default Gateway Address] settings is wrong,
network access may be disabled. In this case, use VB Initial Setting Tool Ver. 5.0.1 to set
the address again. See "Perform Initial Setting of the Camera" (
If the [IP Address], [Subnet Mask], [Default Gateway Address], [LAN Interface] or
[Maximum Packet Size] setting is changed, the camera may become no longer accessible
from the active browser. Check beforehand the precautions explained in "Notes" in "Setting
the Items Requiring Rebooting (Reboot Item)" (
same section before changing each setting in "IPv6" (
If [Auto (DHCP)] is selected as the address setting mode, the IP address may not be
assigned correctly in certain environments, such as when a router is present between the
DHCP server and this camera. In this case, assign a fixed IP address by selecting
[Manual].
If you are using IPv6, set 1280 or greater value under [Maximum Packet Size].
Tip
If optical fiber or ADSL is used, slightly decreasing the maximum packet size may increase
the sending efficiency.
The IP address assigned by [Auto (DHCP)] can be checked using the VB Initial Setting
Tool.
IPv6
(1) [IPv6]
Select [Disable] or [Enable] regarding the use of IPv6.
(2) [IPv6 Address]
If [Enable] is selected for IPv6, an automatically acquired address will be shown.
Tip
In an environment where IPv6 cannot be used, the [IPv6 Address] field remains blank even
when [Used] is selected for IPv6.
Setting the Administrator Password, LAN, IPv6, DNS, etc. (Network)
Start Guide).
P. 1-46). Also check the precautions in the
P. 1-9) and "DNS" (
1
1
P. 1-10).
1-9