Table of Contents
Advertisement
3. Requirements
In order to install the DPH-10U VoIP USB Phone you will need the following:
1. DPH-10U VoIP USB Phone
2. PC with the following minimum specifications:
o Pentium 400MHz or equivalent
o Windows 2000 or XP
o Available USB port (1.0, 1.1 or 2.0)
o Skype™ version 1.1.079 or higher (
o 128MB RAM
o 10MB available hard disk space
o CD-ROM drive to install DPH-10U software from the supplied
CD-ROM
4. DPH-10U Installation
The following instructions will guide you to through the process of installing
the DPH-10U VoIP USB Phone.
The installation procedure is to:
• Install Skype™ (step 1 below)
• Plug in the DPH-10U WHEN INSTRUCTED TO DO SO (step 2 below)
• Start the DPH-10U software installation (step 3 below)
• Following the installation is OK (step 3 below)
• Use your DPH-10U to make Skype™ calls
The detailed instructions follow:
STEP 1:
If Skype™ is not already installed on your computer, visit
http://www.skype.com
that Skype™ is working before installing the DPH-10U.
STEP 2:
Connect the DPH-10U USB port as shown below.
You will see the following popup. Press Yes to proceed or No to cancel.
Connect to PC
and follow the instructions there to install Skype™. Verify
www.skype.com
Connect to NB
4
) must be installed
Advertisement
Table of Contents
