D-Link DWL-G700AP Manual page 13

Using the Configuration Utility (continued)
Beacon Interval:
packets sent by an access point
to synchronize a wireless network.
Specify a beacon interval value.
Default (100) is recommended.
RTS Threshold:
should remain at its default
setting of 2,432. If you encounter
inconsistent data flow, only minor
modifications to the value range
between 256 and 2,432 are
recommended.
Fragmentation:
should remain at its default setting
of 2,346. If you experience a high packet error rate, you may slightly increase your
fragmentation threshold within the value range of 256 to 2,346. Setting the fragmentation
threshold too low may result in poor performance.
DTIM Interval (Beacon Rate):
between 1 and 255 (default is 3) for the Delivery Traffic Indication Message (DTIM.) A
DTIM is a countdown informing clients of the next window for listening to broadcast and
multicast messages.
TX Rates:
Select the transmission rate for the network.
Authentication:
Open System - Communicates the key across the network.
Shared Key - Devices must have identical WEP settings to communicate.
WPA - WPA authentication in conjunction with a RADIUS server.
WPA-PSK - WPA authentication without a RADIUS server in the network.
Mode Setting:
For utmost speed, select G Mode to include only 802.11g devices in
your network. Select Mix Mode to include 802.11g and 802.11b devices in your network.
Preamble:
Long Preamble is the default setting. (High traffic networks should use the
shorter preamble type.) The preamble defines the length of the CRC block (Cyclic
Redundancy Check is a common technique for detecting data transmission errors) used
in communication between the access point and the wireless network adapters.
SSID Broadcast:
the SSID name across the network. SSID is a name that identifies a wireless network.
All devices on a network must use the same SSID to establish communication.
Antenna Transmit Power:
antenna power can be useful for security purposes.
Advanced > Performance
Beacons are
This value
This value
(Delivery Traffic Indication Message) Enter a value
(Service Set Identifier) Enable or Disable (default) the broadcast of
Select the transmission power of the antenna. Limiting
13