D-Link AirPlus G DWL-G630 Manual page 13

Configuration Utility (continued)
D-Link AirPlus DWL-650+ 2.4GHz Wireless Cardbus Adapter
Configuration
SSID: Service Set Identifier is a name that identifies a wireless network. Access points
and wireless devices attempting to connect to a specific WLAN (Wireless Local Area
Network) must use the same SSID.The default setting is default.
Wireless Mode:
Infrastructure
default setting.)
Ad-Hoc - Wireless mode used when connecting directly to a computer equipped
with a wireless adapter in a Peer-to-Peer environment.
Channel: The channel selection is automatically determined by the DWL-G630. In Ad-
Hoc mode, the channel must be manually set to the same channel for each wireless
adapter.
Tx Rate: Tx rates are automatically determined for an optimal speed up to 54Mbps.
Preamble: Select Long or Short preamble. The Preamble defines the length of the CRC
block (Cyclic Redundancy Check is a common technique for detecting data transmission
errors) for communication between the access point and the wireless network adapters.
High network traffic areas should use the shorter preamble type.
Power Mode: Select from three modes:
Continuous Access Mode
Maximum Power Save -
Power Save -
Click Apply to save the changes.
Click on the pull-down menu; select from the following options:
- Connecting to the WLAN using an access point. (This is the
- This default setting consumes the most power.
This setting consumes the least power.
This setting consumes a moderate amount of power.
13