Using A Telephone With The Dvc-1000 - D-Link DVC-1000 Manual

Using the Setup Wizard (continued)
System Restart
A warning message now
appears asking to restart the
DVC-1000 VideoPhone to
complete the setup. Press
the Yes button to accom-
plish a restart.
Congratulations! You are now ready to make and
receive i2eye VideoPhone calls.

Using a Telephone with the DVC-1000

Although optional, it is recommended that you connect a standard telephone
to the DVC-1000 VideoPhone.
The telephone that you use for the DVC-1000 VideoPhone will not
be connected to your phone jack. You will use the telephone as a
means of conducting and receiving calls over the Internet only.
The telephone handset is used to place video calls just as you would with a
regular phone call. You dial a VideoPhone number to reach a party on the other
end of the VideoPhone call. You can speak through the telephone, listen to the
other party in privacy, and even switch to the Speakerphone Mode on the
DVC-1000 to share the audio with others. This can all be controlled by the re-
mote control. When the phone is picked up, the microphone is muted.
If the VideoPhone number you are calling has a different area code, you will
need to dial a "1", the 3-digit area code and the 7-digit number. The DVC-1000
requires using a "1" in calls outside your area code to correctly look up the
phone number.
If you are calling within the same area code, you will only dial the 7-digit num-
ber.
13