Table of Contents
Advertisement
+
Water softening
system/Special salt
W a t e r
n g
s o f t e n i
To ensure good washing results,
the dishwasher requires soft water, i.e.
containing low amounts of lime,
otherwise white limescale will be
deposited on the utensils and inner
container.
Tap water above a specific
degree of water hardness must be
softened, i.e. descaled,
for use in a dishwasher. Water
is softened with special salt in the water
softening system of the dishwasher.
The setting and therefore the required
amount of salt
depends on the degree of hardness of
your tap water (see table).
Water hardness table
Water softening system/Special salt
a l
s y s t e m / S p e c i
s a l t
Setting
The amount of salt dispensed can be
set in 4 stages
depending on the hardness of your
water. Accordingly 0, 1, 2 or 3 displays
are lit (see table). Factory setting: 1.
1. Find out about the hardness
value of your tap water. Your water
utility company will help you with this.
2. Setting can be found in the water
hardness table.
3. Open the door.
4. Switch on ON/OFF switch (.
5. Hold down button > P and press
START button h until the dry
display ` and salt refill
indicator )* flash.
6. Release buttons.
The salt refill indicator )* flashes
and the display # is lit
(= Setting 1).
To change the setting:
1. Press the button < H until
the required setting has been
selected.
2. Press START button h.
The displays ` and )* go out.
The selected setting is saved.
3. Close the door.
en
11
Advertisement
Table of Contents
