Basic Operation; Switching On The Appliance; Operating Tips; Switching Off The Appliance - Bosch KDN76AW41B User Manual

en Basic operation

Basic operation

7 Basic operation
Basic operation
7.1 Switching on the appli-
ance
Electrically connect the appliance.
1.
→ Page 15
Note: If the appliance has been
previously switched off using the
control panel, press and hold
for ten seconds.
a The appliance begins to cool.
a A warning tone sounds, the tem-
perature display (freezer compart-
ment) flashes,
and the status display lights up red
because the freezer compartment
is still too warm.
Switch off the warning signal using
2.
.
goes out as soon as the
a
set temperature has been reached.
Set the required temperature.
3.
→ Page 18
7.2 Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the set temperature has
been reached.
¡ The front and side panels of
the housing heat up occasionally.
This prevents condensation from
forming.
¡ When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
7.3 Switching off the appli-
ance
Press and hold
▶
18
lights up
for ten seconds.
7.4 Setting the temperature
Setting the refrigerator
compartment temperature
Select the refrigerator compart-
1.
ment using
Press / repeatedly until the
2.
temperature display (refrigerator
compartment) shows the required
temperature.
The recommended temperature in
the refrigerator compartment is
4 °C.
Setting the storage container
temperature
To reduce the temperature, slide
1.
the temperature controller in the
direction.
To increase the temperature, slide
2.
the temperature controller in the
direction.
→ Fig.
10
Setting the freezer compartment
temperature
Select the freezer compartment
1.
with .
Press / repeatedly until the
2.
temperature display (freezer com-
partment) shows the required tem-
perature.
The recommended temperature in
the freezer compartment is
−18 °C.
7.5 Button lock (childproof
lock)
The button lock prevents the appli-
ance from being operated accident-
ally or incorrectly while running.
Switching on the button lock
Press and hold
▶
three seconds.
lights up.
a
.
for