Advertisement
EAU00124
Turn signal switch "< >>"
To signal a right-hand turn, push this
switch to the right. To signal a left-hand
turn, push this switch to the left. When
released, the switch returns to the cen-
ter position.
Since this model
is equipped with a
self-canceling system, the turn signal
lights will self-cancel after the motor-
cycle has traveled both about 150 m
(490 ft) and for approximately 15 sec-
onds. However, the turn signal lights
can
also be canceled
manually
by
pushing the switch in after it has re-
turned to the center position.
NOTE: SSS
The self-canceling system only oper-
ates when the motorcycle is moving, so
that the turn signal lights will not self-
cancel while you are stopped at an
intersection.
INSTRUMENT AND CONTROL FUNCTIONS
1. Engine stop switch
2. Start switch " ©"
EAU00138
Engine stop switch
Set this switch to "X " to stop the en-
gine in case of an emergency, such as
when
the
motorcycle
overturns
or
when the throttle cable is stuck.
EAU00143
Start switch * ©"
Push this switch to crank the engine
with the starter.
EC000005
CAUTION:
See page 5-1 for starting instruc-
tions prior to starting the engine.
3-4
1. Clutch lever
EAU00152
Clutch lever
The clutch lever is located at the left
handlebar
grip.
To
disengage
the
clutch, pull the lever toward the handle-
bar grip. To engage the clutch, release
the lever. The lever should be pulled
rapidly and released slowly for smooth
clutch operation.
The
clutch
lever is equipped
with a
clutch switch, which is part of the ignition
circuit cut-off system. (See page 3-19
for an explanation of the ignition circuit
cut-off system.)
Advertisement
