Remove the LCD module
Make sure the following FRU (CRU) has been removed.
"Remove the lower case" on page 28
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2.
Peel off the pieces of tape.
Figure 33. Peel off the pieces of tape
Step 3.
Detach the main and auxiliary antenna cable connectors. Disconnect the sensor cable and the EDP
cable from the system board and release the cables.
Figure 34. Disconnect the sensor cable and the EDP cable and release the cables
.
Chapter 4
Removing a FRU or CRU
45