Hose Drainage - Silvercrest SLE 200 B2 Operating Instructions Manual

Hose drainage

In very humid rooms, it often makes more sense to drain off the water directly via a
hose rather than collect it in the water tank
or the EU garden hose adapter
ATTENTION!
► When draining via the hose, the appliance runs continuously. When draining
via the hose, make sure that it is not kinked and that it runs downwards along
the entire length. Otherwise, the water may flow back into the
appliance and damage it.
► Check the entire connection system regularly for leaks.
♦ Remove the stoppers
♦ Connect either the supplied hose
the water outlet opening
♦ When using the EU garden hose adapter
the EU garden hose adapter
Fig. 4
ATTENTION!
► Screw the EU garden hose adapter
Do not use a wrench as this may damage the EU garden hose adapter
Note
► Depending on the garden hose system you use, you may need an additional
adapter. These are available from specialist stores.
♦ Set up the appliance so that the end of the hose is positioned over a drain.
The open end of the hose must lie below the water outlet opening
appliance (i.e. the hose must have a downwards gradient).
SLE 200 B2
4
. You can use the supplied hose
f
to set up a permanent drainage outlet.
9
from the water outlet opening
d
or the EU garden hose adapter
0
(see figures 4 and 5).
f
f (see figure 5).
Fig. 5
f
hand-tight only.
0
.
, screw a garden hose onto
0
GB │ IE
d
f
to
f
.
of the
│ 17 ■