Operation - Pioneer ERV035AVTTW5W Owner's Manual

Operation

Fan Speed
Indicator Light
Working
ON/OFF
Mode
Fan Boost
Mode
Negative Ion
ON/OFF
Filter Reset
ON/OFF
Remote Control
Remote Controller
1. Fan Speed: Switches the fan speed of the device. There are 3 speeds in total.
2. Working Mode: Switches the working mode of the device (supply mode, exhaust mode, regeneration mode).
3. Negative Ion ON/OFF: Negative ion generator power socket work switch, (when the negative ion function
is turned on, the device supplies air with the power supply. Negative ion generator
is purchased separately and added on).
4. Indicator Light: Control indicator light for On and Off.
5. Fan Boost Mode: Sets the fan into fan boost mode, where the fan runs at maximum power if there is no
other setting. The device runs this mode for 30 minutes before exiting automatically.
6. Filter Reset: After replacing the filter of the inner air duct, press and hold the button for 5 seconds, the device
red light flashes three times, and the filer cleaning time is reset. (Reset time default: 720 hours)
7. ON/OFF: Turn ON/OFF the device.
This remote control uses infrared signals.
1. Before using the remote control, insert the battery into the remote control and close the
battery cover tightly.
2. After inserting the battery, screw the battery cover clockwise as shown until the cover triangle arrow
indicates the locking pattern, which means it is locked (Do not tighten the cover with your bare
hands to avoid potential injury).
3. To remove the battery, turn the battery cover counterclockwise as shown in the picture until the
triangle arrow of the cover indicates the unlocking pattern. Once loose, the battery can be removed.
4. Please store the remote control properly to prevent children from attempting to swallow batteries and/or
other potential accidents.
Button cell CR2025
Cover
Please insert the button cell (prepared by user)
before attempting to use the controller.
13
Operation
PAIRING SYNCHRONIZATION FUNCTION
The suggested maximum distance is 50 feet
Master Unit
1. Without setting a master/slave role, one remote control can control one or more devices.
2. After setting the master/slave role, the current use of the remote control can only control the master,
and the master forwards the synchronization signal to the slave (the slave does not receive the remote
control signal), so that the slave mode is synchronized with the master.
(The master can only control one slave alone).
3. In regeneration mode, the operation direction of the slave fan is opposite to that of the master,
and the direction of the slave fan in other modes is the same as that of the master.
•
The maximum linear unobstructed communication signal distance between master and slave is 50 feet.
•
The signal from the master and slave can pass through an up to 7 inch thick brick wall.
Slave Unit
Note: When controlling the device via remote control,
point the remote control at the device head-on.
14