Table of Contents
Advertisement
IMPORTANT:
information. To prevent loss of information, save your work or shut down the computer through
Windows before you remove the battery.
Remove the battery:
1.
Disconnect the battery cable (1) from the system board.
2.
Remove the seven Phillips M2.0 × 4.5 screws (2) that secure the battery to the computer.
3.
Remove the battery (3).
4.
When installing a new battery, be sure to install the foam pad in the location shown in the following
illustration, aligned with the bottom of the battery, 60 mm from the left side.
To install the battery, reverse the removal procedures.
NOTE:
When replacing the battery, be sure to completely reassemble the computer and plug in the
AC adapter before turning the computer on.
Solid-state drive
To remove the solid-state drive, use this procedure and illustration.
Table 5-3
Solid-state drive descriptions and part numbers
Description
2 TB, PCIe 4 × 4, TLC
1 TB, PCIe 4 × 4
32
Chapter 5 Removal and replacement procedures for authorized service provider parts
Removing a battery that is the sole power source for the computer can cause loss of
Spare part number
M52027-005
N45474-005
Advertisement
Table of Contents
