Table of Contents
Advertisement
f/
stop Priority Method
1
Set the preset aperture ring at the desired
fj st'Op.
2
Face the camera towards the subject, look into the
viewfinder, and press the metering lever
.
3
While pressing or locking the lever, turn the shutter
speed dial.
4
Set the meter needle at the
"
0"
index withinthe
viewfinder for correct exposure
.
•
Since the shutter speed dial cannot be set at the
intermediate positions, the shutter speed priority method
is recommended when exposure accuracy is a crucial
factor.
•
Light measurement at " B
"
and" X" of the shutter
speed dial is not possible with the built·in exposure meter
because" B" is used for long exposures over one second,
and" X" is for the electronic flash unit
.
•
When the built-in exposure meter is outside the coupling
range, the meter needle will point to the top of the
view-
finder and will indicate that proper exposure cannot be
obtained.
Refer to
"
Coupling Range of Built-In Exposure
Meter" on the following
page.
•
Do not leave the camera on the conditions mentioned
above since the battery discharges in maximum current and
makes shorter the
life.
To prevent discharging be sure to
re -adjust the shutter speed dial.
19
Advertisement
Table of Contents
