Advertisement
Small amount
of water in
the drum at
end of cycle
Dryer is not installed on
a stable surface.
Dryer is overloaded.
Dry Level selected too high
for load type.
White/light and coloured items
not separated before drying.
Drain hose is blocked
Environmental conditions
may be affecting
dryer operation.
Dryer is overloaded.
Dryer has a fault.
Dryer has not been
levelled properly.
Dryer makes unfamiliar noises.
Dryer is not level.
Dryer is overloaded.
Cycle selection not
appropriate for the load.
Wet items left sitting in the
dryer for long periods of time
before drying.
10
Check whether the drain hose is
blocked.
Check the drain hose is still attached
at the back of the machine, and is not
kinked or squashed.
If conditions are particularly hot,
humid or cold, it is possible vaporised
water may re-condense in the drum
or on the inside of the door
Remove some items from the dryer.
Continuous beeping or a musical
series of beeps with a message
displayed on the display.
Refer to 'Fault codes'.
Adjust the adjustable foot under the
dryer.Refer to 'Levelling the dryer'.
At the start of the cycle the dryer may
make some unfamiliar noises when the
compressor turns on. This is normal.
Ensure the dryer is installed on a flat,
stable surface.
Ensure the dryer is correctly levelled.
Remove some items from the dryer.
Choose appropriate cycle.
Refer to 'Dry Cycles'
Remove some items from the dryer.
Try selecting a lower Dry Level.
Remember to separate white/light and
coloured items before placing them in
the dryer.
Refer to 'Sorting' for tips to prevent dye
transfer.
Advertisement
