Table of Contents
Advertisement
Do not drop the drawer mount case assembly all the
way down.
This will cause damage to the top cover
release catches.
c.
While holding down hinged panel at rear of drawer,
push down on drawer mount case from top.
Release
catches should snap into place.,
16.
From front of cabinet, press in to release full extension
locks and then carefully slide drawer into cabinet, en-
suring that upper front panel and lower front panel are
not bi nd ing.
Ad just upper and lower panel s, if neces-
sary, and tighten hardware.
Gasket on case assembly air
intake (front) should be touching lower front panel.
17.
Slide
drawer in and out several times to ensure that it
slides freely and that binding does not occur.
If
binding occurs, slide assemblies are not properly
aligned.
(Loosen nut plate and adjust to proper
al ignment.)
lB.
Align both latch keepers (see Figure 2-9, item 8), on
both sides of cabinet, with drawer catches when drawer is
in closed posi tion and tighten hardware securing latch
keepers.
19.
Slide drawer in and out several times to ensure that
drawer is locking properly when closed.
2.2.4
Installation of Expansion Drawer's AC Power Cord
The installation of the expansion drawer's ac power cord to
the cabinet's circuit breaker box is as follows:
2-22
1.
Locate circuit breaker box at the rear of cabinet on
left-hand side (see Figure 2-7 and 2-10 and Table 2-3,
item 6).
2.
Remove outer shell of right-angle connector (Table 2-3,
item 5) by unfastening ,two screws.
3 •. Remove circuit breaker box cover (item 17) by removing
three sets of attaching hardware (items 14, 15, and 16).
4.
Loosen right-angle connector (item 5) from circuit break-
er box (item 6), turn right-angle connector up to a 45
0
angle toward front of cabinet, and retighten right-angle
connector to circuit breaker box.
5.
Loosen cable clamp (item 8) holding ac power cord from
upper unit of cabinet.
HONEYWELL CONFIDENTIAL
&
PROPRIETARY
Advertisement
Table of Contents
