Option Menu - Philips 75BDL4003H User Manual

Heat Status
This function allows you to check the thermal status at any
time.
Behavior/Temp.
Fan turn Off
Fan turn On
Close Warning OSD
Show Overheat message
Show Power off message
When the temperature reaches 60°C, the OSD prompts
Temperature Warning.
When the temperature is lower than 59°C, the OSD prompt
message Temperature Warning is removed.
When the temperature reaches 70°C, Device shutdown is
performed.
When Heat Status/Sensor3 > 65°C, the Panel Saving turns
on.
When Heat Status/Sensor3 < 65°C, the Panel Saving turns
off.
Monitor Information
Shows information about your display, including Input source,
Resolution, Model name, SW version, serial number, operation
hours and MAC address.
Information
Input Source Displayport
Resolution
Model Name XXXXXX
SW Version XXXXX
Serial No
Operation Hours 0HR
MAC Address XXXXXX
DP version
DisplayPort support mode.
The options are:
• {DP 1.1} (Default) : DP 1.1 single stream(clone mode)
• {DP 1.2}: DP 1.2
NOTE:
1. The DP version must be set the same for all daisy chain
displays.
2. For 3840x2160, the dot clock timing should be 533MHz.
3. DP 1.1 not support 4K/60Hz timing.
DP 1.1/1.2
HDCP ON
HDCP OFF
OSD Rotation
Landscape/Portrait
Language
Set OSD menu language.
38°C
40°C
59°C
60°C
70°C
Units
SST 4
MST 4
SST 7
MST 4
Configuration2 reset
Reset all settings in Configuration2 menu to the factory preset
values.

6.2.6. Option menu

Picture
Screen
Audio
Configuration 1
Configuration 2
Option
Input Resolution
Set the resolution of the VGA input. This is only required
when the display is unable to detect the VGA input resolution
correctly.
NOTE: This item is functional for VGA input only.
The options are:
• {1024x768 / 1280x768 / 1360x768 / 1366x768}
• {1400x1050 / 1680x1050}
• {1600x1200 / 1920x1200}
• {Auto}: Determines the resolution automatically.
The selected settings will become effective after turning off
the power and turning it on again.
IR Control
Select the operation mode of the remote control when
multiple displays are connected via an RS232C connection.
• {Normal} - All displays can be operated normally by the
remote control unit.
• {Primary} - Designate this display as the primary display
for remote control operation. Only this display can be
operated by the remote control. (In primary mode, IR key
will always be processed regardless the monitor ID/group
settings).
• {Secondary} - Designate this display as the secondary
display. This display can not be operated by the remote
control, and will only receive the control signal from the
primary display via the RS232 connection.
• {Lock All} / {Lock all but Volume} / {Lock all but Power}
/ {Lock all except PWR & VOL}- Lock the remote control
function of this display. To unlock, press and hold the
[ ] INFO button on the remote control for 6 (six)
seconds.
Keyboard Control
Choose to enable or disable the display keyboard (control
buttons) function.
• {Unlock} - Enable the keyboard function.
• {Lock All} / {Lock all but Volume} / {Lock all but Power}
/ {Lock all except PWR & VOL} - Disable the keyboard
function.
35
Input Resolution
IR Control
Keypad Control
Tiling
Off Timer Off
Date and Time
Schedule
HDMI with One Wire Off
Auto Signal Detection
Power Save
USB Autoplay Off
Slideshow Duration 4 Sec
75BDL4003H