Connections; Using Your Instrument With Other Devices; Connecting Audio Devices; Master Volume] Control - Yamaha PSR-S710 Owner's Manual

Connections

– Using Your Instrument with Other Devices –
CAUTION
Before connecting the instrument to other electronic components, turn off the power of all the
components. Also, before turning any components on or off, make sure to set all volume
levels to minimum (0). Otherwise, electrical shock or damage to the components may occur.

Connecting Audio Devices

Using External Audio Devices for Playback
You can connect a stereo system to amplify the instrument's sound by using the
OUTPUT [L/L+R]/[R] jacks. When using the PSR-S910, the microphone or guitar
sound connected to the instrument's [MIC/LINE IN] jack is output at the same time.
When these are connected, you can use the instrument's [MASTER VOLUME]
control to adjust the volume of the sound output to the external device.
Playing External Audio Devices with the Built-in Speakers
10
You can connect the output jacks of an external device (such as CD player, tone
generator, etc.) to the instrument's AUX IN [L/L+R]/[R] jacks, letting you hear the
sound of that device through the built-in speakers of the instrument.
88
PSR-S910/S710 Owner's Manual
Phone plug
(standard)
Audio cable
Phone plug
(standard)
Audio cable
Powered speaker
Input jack
Phone plug
(standard)
CD player,
Tone generator
LINE OUT
Pin plug
NOTE
Use audio cables and adaptor plugs
having no (zero) resistance.
NOTE
Use only the [L/L+R] jack for connec-
tion with a monaural device.
CAUTION
When the instrument's sound is
output to an external device,
first turn on the power to the
instrument, then to the external
device. Reverse this order when
you turn the power off.
CAUTION
Do not route the output from the
[OUTPUT] jacks to the [AUX IN]
jacks. If you make this connec-
tion, the signal input at the
[AUX IN] jacks is output from
the [OUTPUT] jacks. These con-
nections could result in a feed-
back loop that will make normal
performance impossible, and
may even damage both pieces
of equipment.
CAUTION
When the sound of an external
device is output to the instru-
ment, first turn on the power to
the external device, then to the
instrument. Reverse this order
when you turn the power off.
NOTE
Use only the [L/L+R] jack for connec-
tion with a monaural device.
NOTE
The instrument's [MASTER VOL-
UME] setting affects the input signal
from the [AUX IN] jacks.