Panasonic CF-VDD283 Operating Instructions Manual page 8

Software Preparation (first time only)
Using the DVD-ROM Drive Pack in the MS-DOS Mode
below are performed without completing the preparations first, the drive will not op-
erate properly.
| 1 Click the [Start] button then select [Shut Down].
E 2 Select [Restart in MS-DOS mode] and click [OK].
3 Open the "CONFIG.SYS" file for editing by issuing the following commands:
cd (Enter)
edit config.sys
4 Move the cursor to the line containing "DAKCDROM.SYS" and delete the characters
"rem" at the beginning of the line. (Deleting "rem" causes the item to become valid.)
DEVICEHIGH=C:\WINDOWS\COMMAND\OAKCDROM.SYS /D:MSCD000
(If this line is missing, add it.)
5 Press CAIt) +(F) ‚then($) to save the file. Then press CAIt) +(F), then CX) to
exit the Edit program.
6 Follow the same steps to edit the "AUTOEXEC.BAT" file.
edit autoexec.bat
/ Move the cursor to the line containing "MSCDEX.EXE" and delete the characters "rem"
at the beginning of the line. (Deleting "rem" causes the item to become valid.)
LOADHIGH CAWINDOWSYCOMMANDWMMSCDEX.EXE /D:MSCD000 /L:L
(If this line is missing, add it.)
8 Press CAIt) +(F) 、then(S)to save the file. Then press +Œ), then GO to
-exit the Edit program.
9 Restart the computer.