Pre-Maintenance Procedures; Disconnecting The Spark-Plug Wire; Lubrication; Lubricating The Slicer-Shaft Bearings - Toro 23512 Operator's Manual

Pre-Maintenance
Procedures
Disconnecting the
Spark-Plug Wire
Before performing any maintenance on the engine,
belt, or cutting blades, disconnect the spark-plug wire
from the spark plug (Figure
Figure 15
1. Spark-plug wire
15).
g252737

Lubrication

Lubricating the Slicer-Shaft
Bearings
Service Interval: Every 25 hours—Grease the
slicer-shaft bearings.
1. Shut off the engine, wait for all moving parts to
stop, and remove the spark-plug wire.
2. Engage the parking brake.
3. Lubricate the fittings
pumps of NLGI grade No. 2 multi-purpose
grease.
1. Grease fitting
19
(Figure 16) with 1 or 2
Figure 16
g021348