Registering Your Called Party; Information - Sony RSE-500 Operating Instructions Manual

Is Input
You can register up to 10 called parties for one port
number of the ALARM IN port when an alarm signal
is input. If an alarm signal is input, the unit calls these
parties automatically.
Registering Your Called Party
Information
1
Select 6. LIST (ALARM) from the SETTING
menu.
The LIST (ALARM) menu appears.
LrST(fiLftRM)-
[PORT i1
P0RT2
P0RT3
P0RT4
PORTS
PORTS
PORT?
PORTS
<EXIT> <00
2
Select the port number (PORT 1 - 8) using 4 or ♦.
then press ENTER.
The following screen appears.
-LIST(QLflRM)-PORTI
2
.
3 .
4 .
5 .
6 .
?
.
8
.
9 .
1 0
. ,_
<t> <♦> <EXIT> koto
Select the list number (1 10) to register the called
party using 4 or ♦, then press ENTER.
The following screen appears.
SITE NPME:
[********************]
<71T)
[iRBOj
0123456789
PBCDEFGHIJKLMNOP
ORSTUUUXYZ
abcdefghiJklmnop
qrstuuujxyz
! " a$V.8. I
< = >?©[\'_) ( )-Tx/\©
5P B5
<CfiNCEL> <0IO
Press 4 and select the site name using 4 or 4, then
press ENTER character by character.
The selected characters are entered in the site name
box.
• A site name can be up to 20 characters long.
• Select SP for a space.
• An asterisk is displayed where nothing is entered.
Move the cursor to <OK> using 4, then press
ENTER.
The following screen appears.
SITE name:
OFFICE B
1ST TELEPHONE NO:
II^*********************]
SUB ADDRESS : !**********!
2ND TELEPHONE NO:
SUB ADDRESS:!**********]
it 23456789 BS
select:IB m SINGLE DUAL
<CANCEL> <0K>
Enter the telephone number for B1 -channel using
•4 or then press ENTER one by one.
The selected numbers are entered in the first
telephone number box.
• A telephone number can be up to 22 digits.
• An asterisk is displayed where nothing is entered.
7
Press 4 and enter the subaddress for B1 -channel
using 4 or 4
,
then press ENTER.
The selected numbers are entered in the subaddress
box.
• A telephone number can be up to 10 digits.
•An asterisk is displayed where nothing is entered.
8 Press 4 and repeat steps
6
and
7
to regi.ster the
telephone number and subaddress for B2-channel.
Press 4 and select the transmission rate (via an
ISDN line from IB or 2B, via the V.35 interface
from SINGLE or DUAL) using 4 or 4
,
then press
ENTER.
The setting is registered and the LIST (ALARM)
menu appears.
Note
The subaddress function may not be worked properly
depending on types of switchboards.