Motorola WM800 User Manual page 4

MN010200A01-AC
Safety and Legal
2. This device must accept any interference received, including interference that may cause undesired
operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that in-
terference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
● Consult the dealer or an experienced radio or TV technician for help.
RF Energy Exposure and Product Safety Guide for
Portable Two-Way Radios
CAUTION:
Before using this product, read this guide which contains RF energy awareness information and
operating instructions.
For information on product details, user manuals, and approved accessories, refer to
www.motorolasolutions.com.
The WM800 Remote Speaker Microphone (RSM), when attached to the radio, is restricted to
occupational use only to satisfy RF energy exposure requirements.
Compliance with RF Exposure Standards
National and international regulations require manufacturers to comply with the RF energy exposure
limits for portable two-way radios before they can be marketed. Your Motorola Solutions two-way radio
is designed, manufactured, and tested to comply with all applicable national and international regulations
for human exposure to radio frequency electromagnetic energy. When two-way radios are used as a
consequence of employment, applicable regulations may require users to be fully aware of and able to
control their exposure to meet occupational requirements.
RF Energy Exposure Awareness and Control Information and Operational Instructions for
Occupational Use
NOTE: This device is intended for use in occupational/ controlled conditions where users are aware
of their exposure and can exercise control over their exposure to meet the requirements in national
and international regulations. This radio device is not authorized for general population, consumer
use.
For more information on what RF energy exposure is, and how to control your exposure to ensure
compliance with established RF exposure limits, consult the following websites:
● https://www.fcc.gov/
● https://www.osha.gov/
● https://osha.europa.eu/en
4