Sharp QA-1200 Operation Manual page 20

4.1 IMAGE ADJUST mode
1) Use the SELECT button to shift the highlight box over the item to be adjusted.
IMAGE ADJUST
H-POS V-POS
CONTRAST — ----------- a
2) Use the + and - buttons to change the setting value.
[_ Meaning Pressing - Pressing + |
PHASE Adjust screen flicker. Decreases Increases
|H-POS Adjust horizontal position. Shifts left Shifts right
V-POS |Adjust vertical position. Shifts down Shifts up _
FREQ Adjust the frequency. Decreases Increases
CONTRAST _|Adjust the contrast. Decreases Increases
NOTE
The +/- line bar only indicates Contrast adjustment.
4.2 AWN (audio/video) ADJUST mode
1) Use the SELECT button to highlight the item to be adjusted.
2) Press the + and - buttons to change the setting value.
Item Meaning Pressing - Pressing +
|
AUDIOCTL |Switch the built-in speaker or|Select one of PC (COMPUTER only on), VIDEO
AUDIO output on and off. (VIDEO only on), or OFF (all off).
Adjust the volume from the built-in] Decreases
__|speaker or external speakers.
| VOLUME Increases
TINT Adjust the picture hue. Becomes more purple Becomes greener
{COLOR Adjust the saturation of the image. | Decreases Increases
BRIGHT Adjust the brightness of the image. |Decreases Increases
NOTE
The TINT adjustment is for NTSC signals. Tint has no effect in PAL and SECAM modes.
Attempting to change the tint adjustment other than in NTSC mode causes the message "INVALID" to
appear flashing in the upper right corner.
18