Table of Contents
Advertisement
■ Detailed settings for in/outdoor units
●
Main Unit No.: Select main unit No. as a representative unit for the RC group from a range of 00-00 to 63-63
(refrigerant cycle - address).
Main unit No. is required to be a combination of refrigerant cycle and address that have been detected by Central
Station EX.
Main unit No. need to be the same value on ones in the same RC group. Modify the parent number on this section if
detected main unit No. for the unit and actual system confi guration of RC group do not match.
●
Register total heat exchanger: Set as [Inactive].
●
Capacity control/Lower noise: The item selected as [Inactive] will not be displayed in monitor/schedule window.
The confi guration of [Active] and [Inactive] on this section is refl ected on the item display for other windows.
●
Outdoor temperature representative unit setting: Select [Active] and the temperature sensed on the given outdoor
unit is shown on the upper part of the screen.
NOTICE:
● Setting lower noise to units that do not support the function may cause malfunction on capacity control.
● The setting for capacity control/lower noise is applied in approximately 15 minutes.
32
Follow "■ Check connecting status for
units" (page 27) to show units to register.
1. Tap unit to register.
1
2.
Tap [Register unit details].
The window to register unit details is
shown.
2
3.
Tap [˄] or [˅] to change setting.
●
On detail setting for indoor units, set
"parent number" and "register total
heat exchanger".
●
On detail setting for outdoor units,
set "Capacity control and Lower
4
noise" and "Outdoor temperature
representative unit setting".
4. Tap [
] to confi rm setting and to
return to registering monitoring target
3
window.
Tap [
] to discard the change and
to return to register monitoring target
window.
●
Upon completing the setting,
tap [
] to resister contents as
described in step 9 of "■ Registering
unit names" (page 31).
A12124820A
Advertisement
Table of Contents
