GE 4PE21A1 Instructions Manual page 14

EBI-3657
It
should
be
noted that
the 117 volts
a
-c is supplied
to the
equipment at'beth
the rack
and the console.
All the interconnecting
cables have been supplied except
the 75 ehm coaxial cables and
the
a -c
power input cables.
1.
Cable Interconnections
a. Two cables (PL -766693267) are provided with
a
combined
length
of up to
200 feet.
One of these cables
is to
be
connected
between
J1 on the
Vidicon Camera, and
J1 en the
Interconnecting
Panel, and the seceRd cable
is is
be
connected between
J2 of the
Interconnectiea Panel and
J2 en the Type TP -32-A Power Supply.
b. The
prepared rack
cable harness
is te be connected
between
J1 on the Thsa TP -32-A
Power Supply and J17
en the Channel
Amplifier, and
J1 en the
Type TP -23-A Power Supply.
c.
Three RG -58/U
50
ehm cables have been
supplied and must
be
connected
iu the
_
following manner.
These sables
are te be
connected between
the Type TP -32-A
Power Supply and
the
Channel
Amplifier.
Channel Amplifier
TP -32-A Power Supply
Ji
J9
J10
J1
J9
J10
d.
Connect
the RG
-59/11
75 ohm cable (or similar cable)
between
J2 en the Channel Amplifier and
J2 on the Master:
Monitor.
The video output jack,
J3, en the Master Monitor
is
terminated with
75 ohms or optionally extended
te auxilliary monitoring equipment.
Additional Channel Amplifier outputs
are
available
at jacks
J3, J4,
and
J5.
e.
The
Interconnection Panel possesses four cables which
are
connected
as
fellows:
Cable
P1 is connected
to Jl on the Master Monitor.
The three remaining calbes
P3, P4,
and
P5,
are te
be'connected
to their respective jacks
on the Type
TC -58-A Vidicon Control
Panel. Normally
the units are
shipped with these connections
made.
f.
Using RG -59/U coaxial
cable, make the
following con-
nections frea.the station pulse distribution
system:
5