Remote Control Operation - Kenwood KR-896 Instruction Manual

Remote control operation (KR-896/KR-796)
Cassette tape deck
operation keys
Available for the cas-
sette tape deck con-
nected through the
SYSTEM CONTROL
terminals.
When using a single
cassette tape deck,
use the TAPE B
deck.
TUNER operation
keys
PRESET CALL:
Select the preset
stations.
BAND: Switches
the bands.
CD pave r keys
DISC: The DISC key
can be used the disc
selector key of a
multi-dise¢ player
with a disc changer.
For details, read the
instruction manual
provided with the
CD player.
INPUT select key
Change the input
source.
POWER key
Turn the power of
components ON/
OFF.
MUTE key
Press to mute the
volume temporarily.
VOLUME CONTROL
keys
Adjust the volume
level of the unit.
m Operating procedure
KENWOOD
REMOTE CONTROL UNIT
ROSoBo0
System:
Equalizer operation
eys
Mi. CALL: Recall the
equalized patterns
stored In memary.
EFFECT: Turn the
graphic equalizer ef-
fect ON and OFF.
SURROUND proces-
sor be operenon keys
E: Change the
eucind mode
amana Dol raed Ene
SO EREO, By Ass
(OFF).
REAR: Press to ad-
just the rear level.
CENTER: Press to
adjust the center
level
DELAY: Press to ad-
hur the eee time.
ONTROL: Press to
eat the level of
He Avest center, de-
4 st" TONE: Press
to switch the TEST
TONE ON and OFF.
Note:
Change the mode
among NORMAL,
WIDE, PHANTOM
with CENTER MODE
key on the main unit,
Type: RC-S0800
Infrared control
Plug the power cord of the system into an AC wall outlet, and press the
[POWER]key on the remote control unit to turn the power on.
When the power is turned on, press the key of the source component to be
operated.
* When two operation key on the remote control unit are pressed successively,
press each key securely reserving an interval of more than 1 second for each
press.
Components connected via the system control cords can also be remote-
controlled. In this case, please read the instruction manual supplied with your
component.
Notes:
mg Loading the batteries
1 Remove the cover.
Insert two batteries (RG/AA) as
indicated by the polarity marking.
Remote sensor
' on the receiver
Remote control
1. The supplied batteries are intended for use in operation checks. Therefore, their Jives may be shorter than ordinary batteries.
2. When the remote-controllable distance gets shorter than before, replace both batteries with new ones.
3. Malfunction may occur if direct sunlight or the light of a high-frequency lighting fluorescent lamp enters the remote control light
sensor. In such a case, change the system installation position to prevent the malfunction.
8 KR-898/KR-796/KR-596 (En)