Before Applying Power - Kenwood KT-990D Instruction Manual

Before applying power
Important!
U.S.A., Canada, U.K. and Europe
Units shipped to the U.S.A. and Canada are designed
for operation on 120 V AC only.
Units shipped to U.K. are designed for operation on
240 V AC only.
Units shipped to Europe are designed for operation on
220 V AC only.
These units are not equipped with an AC voltage selec-
tor switch and the discussion of such a switch that
follows, should be disregarded.
All other countries
Units shipped to countries other than the above coun-
tries are equipped with an AC voltage selector switch
on the rear panel. Refer to the following paragraph for
the proper setting of this switch.
AC voltage selector
e This unit operates on 120 V or 220-240 V AC. The AC
voltage selector is preset at the factory for the area to
which the unit is to be shipped. However, to avoid damage
due to an incorrect setting because of local variations or
shipping errors, make the following checks.
Note: — $$ — — — — — — —___——
Our warranty does not cover damage caused by excessive
line voltage due to improper setting of the AC voltage selector
switch.
For United Kingdom
The mains plug must be removed from the wall socket
prior to any internal examination.
important
The wires in this mains lead are coloured in accordance
with the following code:
Neutral
The wires in this mains lead must be connected to the
terminals in the plug as follows:
Wire Colour Plug Terminal Marking
N or Black
L or Red
Brown to
Live
Blue to
Neutral = )
Plug
Notes:
1) Ifa13-amp plug is used, this must be fitted with a 5-amp
fuse.
2) If a 3-pin plug with earthing contact is used, no wire
must be connected to the E terminal.
WARNING:
TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
Position 220 V-240 V~
1-1
1. Before plugging in this unit, make sure that the position of
the AC voltage selector conforms to your line (mains)
voltage. If not, it must be reset. See Fig. 1-1.
2. To reset the selector, slide the stopper plate to the op-
posite side with a screwdriver or other pointed tool. See
Fig. 1-2.
3. Insert the power cord securely. See Fig. 1-3.
2 KT-990D (k)