GE MDS TransNEXT NET9L Technical Manual page 47

Progress is shown as follows:
At completion the display will show:
Transfer complete: 1111168 bytes
Validating MPK.....
Updating image...
|
OK
>
Now use the app command to verify that the new 1.0.5 firmware is now loaded as the inactive image.
>app
Image 1 Version:
Image 2 Version:
Finally use the app command to make image 2 the new active image.
>app 2
Confirm switch to Image 2? (y/n)
-
Reboot to APP image: 2
NOTE
The process of the app 2 command above will take a few minutes to complete.
At the completion of this stage the TransNEXT will automatically switch to the new image and reboot.
After reboot the UI connection will need to be reestablished. If using Tera Term, the TransNEXT device
will have a small delay and finally return to the banner and login prompt.
Upon logging in the device may still be finishing programming on an internal radio processor. During
this time the app command will show "unavailable".
>app
Access Denied:
Modem FW Update in Progress
Command failed!
>
After a few minutes the internal operation is complete, and the app command will show the new active
version.
>app
Image 1 Version:
Image 2 Version:
MDS 05-7280A01, Rev. A
1.0.3 (active)
1.0.5
......
1.0.3
1.0.5 (active)
MDS TransNEXT Technical Manual 47