Advertisement
Writing End ID During Playback J
During playback, no end ID can be written on a blank section.
During playback, press END ID WRITE at the desired position.
The REHEARSAL indicator lights, and the portion for 3 seconds to the
point where you pressed END ID WRITE, is played back repeatedly
(rehearsal function). The end of the repeated portion will be the beginning
of the end ID.
ad
Press <4 or PP to adjust the "repeat end"
point.
The "repeat end" point is shifted backward with
Lights.
44 or forward with B®, by 0.3 of a second.
The indicator at the MARGIN shows how much
the "repeat end" point is shifted from the point
y oz 5
END 10
me
Sane
where you pressed END ID WRITE.
It can be shifted up to 70 seconds backward or
forward.
When you pressed P
twice.
After setting the beginning of the end ID at the desired point, press
END ID WRITE again.
"EE" lights, and an end ID is written.
Note on the point where an end ID is written
During rehearsal function, an end ID is written at the end of the
repeated portion as illustrated.
Repeated portion
Point where you pressed END ID WRITE
Repeated portion is played back 16 times, and the tape stops.
Erasing ENGI
Search for the beginning of the end ID with the >
button (page 22).
When the end ID is detected, "EE" lights.
Press END !D ERASE.
If you want to start recording from the point where the end ID is written, you
need not press END ID ERASE.
i
7
SKIP
1D
Lights while the end
ID is being searched
for. >Goes off when
Ce eense} —the end ID is erased.
37
Advertisement
