Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION INSTRUCTIONS
Leveling your laundry center
Excessive noise and vibration can be prevented by
properly leveling the laundry center.
1
With the laundry center within 4 feet (1 m) of its
final location, place a level on top of the washer lid.
2
Use adjustable pliers to adjust the leveling legs so
the laundry center is level front-to-rear and side-to-
side, and stable corner-to-corner.
3
Press down on alternate corners and sides and feel
for the slightest movement. Adjust the appropriate
leg(s) so the laundry center sits solidly on the floor
on ALL four legs. Keep the leveling leg extension at
a minimum for best performance of the washer.
Connecting inlet water
i
Run some water from the hot and cold faucets to
flush the water lines and remove particles that might
clog the water valve screens and to determine which
faucet is hot and which is cold supply.
2
Remove the inlet hoses and rubber washers from the
plastic bag located in the drum of the washer and install
the rubber washers in each end of the inlet hoses.
RUBBER WASHERS
oS
MUST BE PRESENT
USE ONLY
~NEW HOSES
3
Connect the HOT inlet hose to the HOT inlet
connection on the washer and the COLD inlet hose to
the COLD inlet connection on the washer. Tighten by
hand until snug. Then tighten each supply connection
another 2/3 turn with pliers. Do not cross thread
or over-tighten these connections.
4
Connect the HOT iniet hose to the HOT water
supply and the COLD inlet hose to the COLD water
supply. Tighten by hand until snug. Then tighten
each supply connection another 2/3 turn with pliers.
Do not bend, kink or pinch water inlet hoses.
5
Turn on the water and check for leaks.
(COLD)
17
Advertisement
Table of Contents
