Toro Reelmaster 5510 Operator's Manual page 52

Overview of the InfoCenter Display (continued)
1. In Machine Settings, scroll down to Mow Speed.
2. Use the left and right navigation buttons to increase and decrease the maximum mow
speed in 0.8 km/h (0.5 mph) increments between 1.6 and 12.9 km/h (1.0 and 8.0 mph).
Setting the Maximum Allowed Transport Speed
The selected setting is displayed as an X on the traction-speed bar graph along with the
cruise control and pedal stop settings. An X in a bar denotes that the maximum speed is
limited by the supervisor.
Note:
This setting is retained in memory and applied to the traction speed until you change
it.
1. In Machine Settings, scroll down to Transport Speed.
2. Use the left and right navigation buttons to increase and decrease the maximum
transport speed in 0.8 km/h (0.5 mph) increments between 8.0 and 16.0 km/h (5.0 and
10.0 mph).
Setting the Acceleration Mode
1. In Machine Settings, scroll down to Acceleration.
2. Press the right navigation button to switch between L
Checking the Hydrostatic Braking Distance
Note:
This machine will dynamically brake and stop when you return the traction pedal to
neutral.
Note:
For smooth deceleration, use your foot to slowly control the traction pedal back to
neutral. Do not take your foot off the pedal and allow it to snap back to the neutral position
unless you intend to stop quickly.
1. Bring the machine to a complete stop approximately 3.7 m (12 ft) from the maximum
transport speed of 10 mph.
2. On flat, dry pavement, mark out the start and end of 3.7 m (12 ft).
3. Drive the machine at the maximum transport speed of 16 km/h (10 mph) and remove
your foot at the start of the 3.7 m (12 ft).
4. Check if the machine stops within 0.6 m (2 ft) of the end mark (3.7 m or 12 ft).
5. Contact your Toro distributor if the stopping distance of the machine is not within 0.6 m
(2 ft) of this distance.
Overview of Displayed Traction Speeds
This machine displays estimated traction speeds in kilometers per hour (km/h) or miles per
hour (mph).
Note:
The displayed traction speeds are only accurate when the engine speed is set to high
idle.
Operation: Before Operation
OW
Page 5–12
, M , and H .
EDIUM IGH
3464-490 A