Pioneer CT-1160R Service Manual page 7

CT-lN6GOoOR, CT-SSS5SR
3.5 CAPSTAN MOTOR REPLACEMENT 3.6 TAPE HEAD REPLACMENT
. Remove the tape transport unit from the deck.
(see page 5)
2. Loosen the cordfixer A, and free the lead wires.
(see Fig. 3-4-1)
. Remove the lead wire holder. (see Fig. 3-4-1}
. Undo the head securing screws, and pull out the head
assembly.
1. Remove the tape transport unit from the deck.
(see page 5)
2. Disconnect the motor lead wires from the motor.
Head assembly
Fig. 3-5-1
. Same as steps 2 thru 4 of the capstan belt replacement
procedure described above. (see page 6)
4. Remove the capstan motor from the bracket, and
replace it with a new motor.
5. Disconnect the lead wire soldering from the head with
a soldering iron.
Capstan motor
pi Head securing screws
sz
Ser Head assembly
Cushion
Motor bracket
Housing assembly
. Re-assembly in the reverse order (when mounting the
motor, align the speed adjustment hole with the left
hand side when viewed from behind).
. Adjust tape speed.
6. Re-assembly in the reverse order.
7. Execute the "Tape transport adjustment' and
"Electrical adjustments".
Note: After completing the head replacement procedure, always
ensure that the securing screws are sealed.