Table of Contents
Advertisement
You can select Network, Frequency, Network
ID and Search Step from this screen. For
highlighting lines you see, use Up or Down button.
You can set Search Step as 8000 kHz or 1000
kHz. If you select 1000 kHz, the TV will perform
search process in a detailed way. Searching
duration will thus increase accordingly. When
finished, press OK button to start automatic
search.
If you select NO, the following screen will be
displayed:
You can set Start - Stop Frequencies and Search
Step as desired. When finished, press OK button
to start the search.
9. If you select Aerial option from the Search Type
screen,
a confirmation message will be displayed.
If you want to continue with searching select Yes,
the television will search for
Select No to exit.
10. The Auto tuning screen will appear and the
television will start to search for available stations.
The progress bar will move along the line. You
must allow the television to complete the search.
Initial Installation -
avai̇ lable
broadcasts.
English - 16 -
continued
Note: You can press MENU button to cancel.
11. If you select Satellite option from the Search Type
screen, Antenna Type menu will be displayed.
There are three types of antenna selection. You
can select Antenna type as Direct, Unicable
or DiSEqC.
Direct: If you have a single receiver and a direct
satellite dish, select this antenna type. After selecting
Direct, another menu screen will be displayed.
Select an available satellite and press OK to scan
for services.
If wanted, the default LNB frequency
values for the selected satellite can be edited
before starting the search. The frequency values
can be entered in two ways:
• The high band value should be "0" and the low
band value should be entered.
• The high and low band values should be the
same, so this value can be used in search. But
this value cannot be "0".
These are the standard single LNB search
requirements.
Unicable: If you have multiple receivers and a
unicable system, select this antenna type. Press
OK to continue. Configure settings by following
instructions on the screen. Press OK to scan for
services.
DiSEqC switch: If you have multiple satellite
dishes and a DiSEqC switch, select this antenna
type. After selecting DiSEqC switch, another
menu screen will be displayed. You can set four
DiSEqC options (if available). Press GREEN
button to scan all satellites or press YELLOW
button to scan only the highlighted satellite. To
save and exit press OK button.
Advertisement
Table of Contents
