Advertisement
3d-Push
the Main Burner Wire (26b)
onto the back of the Push Button Igniter
(26). Snap the Igniter into the Control Panel,
Figure 4.
The main Burner wire attaches to the
main burner electrode; see figure A.
The Electrode Tip is located on the Burner
assembled in the bottom casting; see figure B.
For the Side Burner igniter use assembly
instructions found in the Side Burner Kit.
26b
4
26
Test the Igniter:
(See Use and Care Manual)
If the spark does not appear:
- Check the wire connection to the Igniter.
- Check the Collector Box electrode installation
to the main burner.
3e-Snap
the Nameplate (56) into the Top
Casting
(55).
Attach the Handle (58) to the Top Casting
with 2 screws (SB) and 2 wing nuts (DZ),
Figure 5.
3f-
Attach the Top Casting assembly to
the Bottom Casting with the 2 clevis
pins (VE) and 2 hair pins (WO). Place
the Heat Tent (61) and
Cooking Grid(s) (63)
into the Bottom
Casting, Figure 6.
55
Z_
CAUTION: This
grill is equipped with a
Heat Tent, DO NOT
use Lava rock or
ceramic briquettes.
5
58
6
VE
11412242
(Pg. 9)
Advertisement
