Availability Of Accessories.17; Use Energy Wisely.17 - KitchenAid 4KUCS181T Use And Care Manual

Drawer Panels —
Free Standing Unit:
1. Disconnect power supply to compactor
before changing panel.
2. Tilt compactor toward rear. DO NOT LAY
UNIT ON ITS BACK OR DAMAGE TO
CORD MAY RESULT.
3. Remove three retaining screws in lower
drawer trim. Remove loosened trim and
slide panels out. HANDLE CAREFULLY SO
THE PANELS WILL NOT BE SCRATCHED
OR BENT. Replace panel so desired color is
exposed, making sure that handle trim
bezel is placed into slots in panels.
4. Replace trim and screws.
Do not operate compactor unless all
parts are fully assembled as injury
may result.
Use Energy Wisely
A trash compactor uses a negligible amount
of energy. Total energy requirements
associated with the trash compactor will be
minimized by following the recommenda¬
tions in this Use and Care Guide.
ENERGY
USAGE
KWH
per month
Cost
per month
2 cycles per day
1.01
$0.08t
fBased on average utility rate of $0.08 per
kilowatt hour.
Availability of Accessories
Trash bags and charcoal air filters may be
obtained from your KitchenAid dealer or
direct from Inglis Consumer Services.
Custom Front Panels to
Accent Kitchen Decor
The stainless steel trim will also accommodate
a locally purchased wood front up to 'A-inch
(6 mm) thick. For more instructions on
installing a wood front, refer to the
Installation Instructions.
A white decorator control panel is available
through Inglis Consumer Services.
Conversion to a Free Standing Unit
Laminated Maple Wood Top Conversion Kit
(Part #4164800) — A beautifully finished,
1-inch thick (25.4 mm), maple wood top is
available through your KitchenAid dealer.
The height of the Compactor with wood top
is adjustable from 35 ^,-inches (892 mm)
to 36%-inches (924 mm).
17