Inspecting And Handling The Unit; Indoor Unit Installation - Bosch Climate 5000 VRF HWM Series Manual

4. INSPECTING AND HANDLING
THE UNIT
At delivery, the package should be checked and any damage should be
reported immediately to the carrier claims agent.
When handling the unit, take into account the following:
1 Fragile, handle the unit with care.
Keep the unit upright in order to avoid compressor damage.
2 Predetermine the route you will use to move the unit to prevent
damage.
3 Move this unit if possible in its original packaging.
4 When lifting the unit, always use protectors to prevent belt damage
and pay attention to the position of the unit's centre of gravity.

5. INDOOR UNIT INSTALLATION

5.1 Installation place
The indoor unit should be installed in a location that meets the following
requirements:
• Avoid installing it in a narrow space which has a high requirement
to noise.
• The ceiling is horizontal, and its structure can endure the weight
of the indoor unit.
• The outlet and the inlet are not impeded, and the influence of
external air is the least.
• The air flow can reach throughout the room.
• The connecting pipe and drainpipe could be extracted out easily.
• There is no direct radiation from heaters.
• Do not install it in a place where the air contains salt. If this can't
be avoided, the unit should be coated with an anti corrosive
coating.
CAUTION
Installing the equipment in any of the following places may lead to
faults of the equipment (if that is inevitable, consult the supplier):
A. The site contains mineral oils such as cutting lubricant.
B. Coastal air.
C. Area where corrosive gases exist, e.g., sulfide gas.
D. Factories where the supply voltage fluctuates.
E. A kitchen where oil permeates.
F. Place where strong electromagnetic waves exist.
G. Place where flammable gases or materials exist.
H. Place where acid or alkali gases evaporate.
I. Other special environments.
Mounted air conditioner indoor unit
INSPECTING AND HANDLING THE UNIT | 5
5.2 Drilling A Hole and Mounting Installation Board
Installation Board and Its Direction (unit: mm)
2.2\2.8 kW
The shape of indoor unit
440
835
3.6\4.5\5.6 kW
The shape of indoor unit
375
990
7.1\8.0\9.0 kW
The shape of indoor unit
561
1194
1 Fix the installation board.
Install the installation board horizontally on structural parts in the
■
wall with the spaces provided around the plate.
In case of brick, concrete or similar type walls,make 5 mm dia, holes
■
in the wall. Insert clip anchors for appropriate mounting screws.
Fix the installation board on the wall.
■
Correct installation
Mounting board of indoor unit
186
45
280
Fig. 5-1
335
53
315
Fig. 5-2
307
55
343
Fig. 5-3
Horizontal line
Fig. 5-4
6720865987 (2018/06)