Husqvarna DC 900 Operator's Manual page 11

higher, it is necessary to clean the primary filters. Refer
To clean the primary filters on page 16 . If the value
to
on the vacuum gauge is 15 cm H
clean the primary filters, it is necessary to replace the
To replace the primary filters on
primary filters. Refer to
page 16 .
Pressure tank manometer
The pressure tank manometer shows the pressure in the
pressure tank. The air in the pressure tank cleans the
primary filters. The pressure is around 7 bar/100 PSI
during operation.
Water separator
The water separator removes dirt, oil and water from the
air.
To connect a secondary product
1. Connect the power plug of the secondary product to
an applicable power supply.
2. Make sure that the dust extraction hoses between
the product and the secondary product are
connected with hose clamps and industrial tape.
2154 - 002 - 25.10.2023
O or higher after you
2
3. Make sure that the dust extraction hoses are in good
condition and can move freely.
To connect the product to a power
source
1. Connect the power plug of the product to a grounded
mains outlet or other power source.
2. Make sure that the mains voltage agrees with the
type plate on the product.
To start the product
To do before you operate the product
1. Do all steps in
on page 9 .
2. Make sure that the airflow hatch on the fan unit is
closed.
3. Make sure that the dust extraction hoses between
the product and the secondary product are attached
correctly.
4. If a warning indicator on the control panel is on, refer
Troubleshooting on page 19 .
to
5. Start the compressor.
6. Start the fan unit and wait until the fan is at full
speed.
11