Advertisement
@ TO REMOVE
P.C. BOARD
1. Remove three (3) knobs, Band Selector, Tone and Volume Controls, from
cabinet.
2. Remove the three (3) screws (nos. 1~3) for the cabinet cover, as shown
in fig. 1.
3. Remove the cabinet cover, as shown in fig. 2.
4. To remove
the cabinet cover completely,
pull out the three (3) lead
sockets of power supply and antenna.
5. Remove the four (4) red screws (nos. 1~4) as shown in fig. 3.
6. Remove the P.C. Board from cabinet.
7. To reassemble,
read the following notes and reverse the above pro-
cedure.
Notes:
1. Turn tuning knob and tuning capacitor shaft fully counter-clockwise.
2. Insert the tuning capacitor shaft in hole of dial drum, as shown in fig. 4,
M@ TO REMOVE
CHASSIS
—
. Remove P.C. Board from cabinet.
(Refer to P.C. Board removai instruction.)
. Remove Tuning Knob.
. Remove five (5) screws
(nos. 1~5), as shown in fig. 5.
. Pull out chassis as shown
in fig. 6.
. To reassemble,
reverse the above procedure.
Qhrohd
M@ DIAL CORD
INSTALLATION
GUIDE
1. Remove chassis from cabinet.
(Refer to chassis removal instruction.)
. Dial Cord length is 135 cm (534").
. Turn dial drum to fully clockwise.
. Arrows (1-~8) indicate correct order and direction of dial cord installa-
tion as illustrated in fig. 7.
5. Cement dial cord ends.
RON
@ TO MOUNT
DIAL POINTER
1. Turn dial drum to fully clockwise.
2. Set dial pointer to start point of dial scale.
3. Attach dial cord to dia) pointer.
Screw No.1 (CHi-14,
| Smee
| cempmmrecemrenncmmmmenmsrresees
Screw No.2 (CHi-14)
Screw No.3 (CHi-14)
Screw No.4 (CHi-14)
Screw No.5 (CHi-15)
Fig. 5
RF-1105LBS
Screw No.1 (CAs)
t
Screw No.2 (CAs)
Fig. 1
HRed Screw No.1 (CHis)
Red Screw No.2 (CHi9)
Red Screw No.3(CHis)
Red Screw No.4 (CH19)
Fig. 3
.
S
Spring
(cr?)
(CHr-8)
Tuning
:
\
Capacitor
Shaft
Drum
(CH1-7)
Fig. 4
Advertisement
