LED Light Kit
TimeCutter
Model No. 147-8757
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
No parts required
Light bracket
Hex-washer-head thread forming screw (5/16
x 3/4 inch)
LED light
Hex-washer-head screw
Wire harness
Cable tie
Preparing the Machine
Gas Models Only
1.
Park the machine on a level surface.
2.
Disengage the blade-control switch.
3.
Move the motion-control levers outward to the P
4.
If equipped, engage the parking brake.
5.
Shut off the machine and remove the key.
6.
Wait for all moving parts to stop.
7.
Allow machine components to cool.
Electric Models Only
1.
Park the machine on a level surface.
2.
Disengage the blade-control switch.
3.
Move the motion-control levers outward to the
4.
Engage the parking brake.
5.
Shut off the machine and remove the key.
6.
Wait for all moving parts to stop.
7.
Allow machine components to cool.
8.
Remove the battery packs from the machine.
© 2023—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Max or TITAN
®
Qty.
–
Prepare the machine.
1
2
1
Install the LED Light Kit.
2
1
1
ARK
NEUTRAL
Register at www.Toro.com.
Riding Mower
position.
position.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
Form No. 3465-864 Rev A
Installation Instructions
Use
*3465-864*