Figure 3
1. Bolt (M12)
2. Castor fork
3. Gearbox
4. Dust cap with O-ring
4.
Use 4 bolts (M12) to secure the gearbox to the
castor fork (A in
Figure
5.
Torque the bolts (M12) to 81 to 95 N∙m (60 to
70 ft-lb).
6.
Install the hub assembly, snap ring, and dust
cap with O-ring on the axle shaft (B in
When you install the snap ring, compress the
wave washer in the hub assembly.
Note:
If the thrust washers and bearing are
removed from the hub assembly, assemble them
as shown in
Figure
7.
Remove the plug from the top of the gearbox
(A of
Figure
4).
5. Snap ring
6. Thrust washer
7. Bearing
8. Hub assembly
3).
Figure
3.
1. Plug
8.
Secure the vent hose and fitting to the gearbox
(B of
Figure
g311730
3).
3
Figure 4
2. Vent hose and fitting
4).
g301398