ABB ACH550-UH-011A-6 User Manual page 207

Code Description
14 =
AT SET POINT
equal to the reference frequency.
15 = (
FAULT RST
condition and will reset after the programmed auto-reset delay.
• See parameter 3103
16 = /
FLT ALARM
17 =
EXT CTRL
18 = 2
REF SEL
19 =
CONST FREQ
selected.
20 =
REF LOSS
location is lost.
21 =
OVERCURRENT
fault occurs.
22 =
OVERVOLTAGE
fault occurs.
23 =
DRIVE TEMP
overtemperature alarm or fault occurs.
24 =
UNDERVOLTAGE
or fault occurs.
25 = 1
AI LOSS
26 = 2
AI LOSS
27 =
MOTOR TEMP
alarm or fault occurs.
28 = – Energise the relay when a stall alarm or fault exists.
STALL
30 =
PID SLEEP
active.
31 = PFA – Use the relay to start/stop motor in PFA control (See
81: PFA CONTROL).
• Use this option only when PFA control is used.
• Selection activated / deactivated when the drive is not running.
32 =
AUTOCHANGE
is performed.
• Use this option only when PFA control is used.
33 =
FLUX READY
and able to supply nominal torque (the motor has reached nominal
magnetising).
34 =
USER MACRO
active.
202
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
– Energise the relay when the output frequency is
) – Energise the relay when the drive is in a fault
DELAY TIME
– Energise the relay when a fault or alarm occurs.
– Energise the relay when external control is selected.
– Energise the relay when
– Energise the relay when a constant speed is
– Energise the relay when the reference or active control
– Energise the relay when an overcurrent alarm or
– Energise the relay when an overvoltage alarm or
– Energise the relay when a drive or control board
– Energise the relay when an undervoltage alarm
– Energise the relay when
– Energise the relay when
– Energise the relay when a motor overtemperature
– Energise the relay when the PID sleep function is
– Energise the relay when PFA autochange operation
– Energise the relay when the motor is magnetised
2 – Energise the relay when User Parameter Set 2 is
Parameter listing and descriptions
ACH550-01 User's Manual
Range
.
2 is selected.
EXT
1 signal is lost.
AI
2 signal is lost.
AI
Group