Advertisement
SOFTWARE INSTALLATION
For Windows 95
Note: In case of problems with the EPP/ECP mode setting, please
check in the BIOS SETUP of your computer (see the manual of your
computer) that your parallel port is configured in EPP or ECP mode
according the list that is shown during installation of this device.
1.
Put the first driver program disk into your floppy drive.
2.
Double click on the "My Computer" icon
3.
Double click on the "Control Panel".
4.
Double click on the "Add/Remove Programs" icon.
5.
Click on "Install"
6.
Follow the instructions of the setup program.
Note: After restarting your system, it is possible that the CD-R/RW
has another drive letter than after initial installation.
Note: To make a back-up recovery disk with the "Seagate( Backup"
program, it is necessary to install the DOS drivers with installation
disk 3. This backup program will prompt you with the question where
it can find the drivers epatcd.sys and aspicd.sys. They can be found
(after the DOS-installation) in the folder C:\EPEZ.
7
Advertisement
